Engine Problem - Mitsubishi-Forums.com
LinkBack Thread Tools
post #1 of 6 (permalink) Old 11-08-2011, 11:32 PM Thread Starter
Join Date: May 2005
Posts: 18

I left my car 7-8 months in garage, did no drive at all, some time started engine to lubricate. Today I started engine and I was going to take a ride after long time, it works fine if you have foot on gas, if it is on idle it shuts down!!!! rpm goes up and down and shuts down. I remember that this car did not have battery for a few days. do u guys know what might be a problem? Computer? memory? need reprogram? Anybody had this problem?

PedjaC is offline  
Sponsored Links
post #2 of 6 (permalink) Old 11-09-2011, 01:23 AM
Super Moderator
chain rattle's Avatar
Join Date: Jan 2006
Location: Ipswich Qld Australia
Posts: 3,863
Send a message via AIM to chain rattle Send a message via Yahoo to chain rattle
voltage problem

engine comp module needs the full 12 volts to function

check charge rate and condition of battery
chain rattle is offline  
post #3 of 6 (permalink) Old 11-09-2011, 09:18 AM
srsone's Avatar
Join Date: Jun 2008
Location: naples,fl
Posts: 4,033
did you have fuel treatment in the fuel?

gasoline can go bad in as little as a month

the injectors could be sticky...the fuel pump.

how did you store it?

did you just park it and do nothing to it?

did you put a new battery in it?

I am a rocker, I am a roller, I am an out of controller!
the nightrider

What the **** is an aluminum falcon?
srsone is offline  
post #4 of 6 (permalink) Old 11-10-2011, 01:39 AM Thread Starter
Join Date: May 2005
Posts: 18
Battery is new, I changed 6 months ago, it has 12v, alternator ok 14 v charge.
It was stored in garage for more than 6 months, i started engine every two weeks, but never drove it.
I never put gasoline treatment, I recently fill up the tank.
How to check rate of charge for computer module? any instructions for this?

PedjaC is offline  
post #5 of 6 (permalink) Old 11-22-2011, 03:53 PM Thread Starter
Join Date: May 2005
Posts: 18
I have P0300 code on OBD 2 scanner, random missfire....any suggestions?
PedjaC is offline  
post #6 of 6 (permalink) Old 01-01-2013, 05:40 PM
Join Date: Mar 2010
Posts: 7
I took out my battery on my 04 edeavor so I could clean the posts well and when I reinstalled it would not idle at all, just died. It drove okay but when I came to a stop I had to rev the engine. Did this for about 5-10 minutes and then it was okay. Unhooked the posts months later and when rehooked it did it all over again. Now it wants to cough, burp, and choke when I stop, okay not as bad but will stall occasionally. Just don't know about this. Could it be from clogged injectors from some of the ethanol gas???
kevyrev is offline  

Quick Reply

Register Now

In order to be able to post messages on the Mitsubishi-Forums.com forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

For the best viewing experience please update your browser to Google Chrome