2003 Eclipse GT 3.0 Camshaft Position Sensor Testing
I have searched here and the Intranet but cannot find a test procedure for the Cam Position Sensor.
I have found articles that explain the basics but not what the actual signal output should be.
This is the 2003 GT 3.0 so I know the Cam Sensor is in the distributor.
I also know I am dealing with pins 5,6 and 7 on the distributor plug.
5 is power, I have 12 Volts here
7 is ground, I have good ground here
6 is Signal out (they call it signal in the articles but I am measuring voltage)
When I back probe 6 with my red test lead and 7 with my black and turn the key on I get 4.88 volts
When I crank I get 2 volt's consistent.
The question is, what voltage should I see out of the signal wire?
Is the 2 volts enough or should it be 12 volts?
Last edited by chain rattle; 02-12-2017 at 04:46 PM.