Mitsubishi Forums banner

2000 Galant Body Side Moulding

1K views 2 replies 3 participants last post by  MitzuB 
#1 ·
The side moulding (ding protection) has started to peel off from the back of the front doors. Does anyone know the best way to fix this? Do I have to buy new or can I use an adhesive product with the old moulding? Any ideas would be appreciated.
 
#3 ·
Try 3M Plastic Emblem and Trim Adhesive 03601, 1 oz tube.
Clean / remove as much of old ashesvive from molding before applying new adhesive. After applying to back of molding, press into place by hand and then use blue painters masking tape to tape molding into place while adhesive dries. Perhaps for an hour or longer. Refer to directions on back of packaging.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top