Mitsubishi Forums banner

How To Reset The Srs Light On Instrument Panel?

139K views 8 replies 8 participants last post by  manybrews 
#1 ·
Anybody have the directions on how to reset the SRS light on hte instrument panel? I think I accidently unplugged it and now the light stays on.
 
#3 ·
Originally posted by unknown_owner@Jun 12 2005, 01:06 PM
Anybody have the directions on how to reset the SRS light on hte instrument panel?  I think I accidently unplugged it and now the light stays on.
[snapback]18904[/snapback]​
Disconnect the battery cable and reconnect. Sometimes it will fix it, if not it has to be cleared with a "mutt" from the dealer
 
#4 ·
you can ensure it resets when the battery is disconnected by popping you fuse cover under the hood and pulling the main ECU relay block waiting a few seconds and plugging it back in. This is also good when you move from a higher to lower elevation and vice versa, it causes the ECU to remap its air density parameters, changin the air/fuel ratio. :thumbsup:
 
#5 ·
Hi. I've the same problem when I installed a Harman Kardon Drive + Play iPod interface in my new Endeavor Limited 2006. I was looking at the list of fuses in the user guide and there is one that says 'Relay'. Is that the same one you are referring to as 'ECU Relay Block'? Thanks for the tip.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top