Hi guyz am trying to change my Mitsubishi Celeste' engine.
What kind of engine should i go for?
Am kinda stuck HELP!!

Ok.. I am need of some serious help.. I currently bought a 1989 Ram 50 with the 2.6 G54B motor, 5 speed 4x4.. I took the old carb off and replaced it with a new head , 38/38 weber, flowmaster exhaust, and performance cam. The truck ran great with the new head except for the fact that oil pumped out of the breather on the back of the valve cover.. The PCV valve works and is also brand new along...

I have a 1994 Pajero with no turn lights. i checked the fuses and they are all good ..... any help ?

my mitsy died rac recovered it to garage wher it spent 2 days being checked out then
it was put on a computer, the throttle body had burnt out mitsey quoted £1200 for new one + fitting
and secondhand ones are £300-£600 but was it worth fixing for that sort of money or do i scrap it
but i have found a place on the net that does remanufactured ones with a 2 yr no quibble no hassle...

hi,


i am jm from the philippines. i am just wondering if you have a relay diagram for headlights. i recently installed a 100/90 watts headlamp, the service advisors of mitsubishi told me to put to more relays for the low beam and high beam. but there's one problem, i don't know what's the positive and the negative wires on my headlamp. my wagon is a mitsubishi...

3856]
I've got this J26 4WD "Jeep" built in 1975 and imported then sold by Colt UK 1980 (I'm 3rd owner from new).
I am looking to replace a blown cylider head gasket but the local Mitsubishi dealer is having problems finding the correct part number (even though the vehicle is in their service bay).
The engine is a 2.6 litre Astron - which I think are...

Hi, default/00000732.gif' '00000732.gif' />

I am from malaysia.

This is first time come this forum.

Hope can be friend with all eterna member.

At malaysia, Mitsubishi eterna = Proton Perdana ( national car )

Hope can exchange all info...

Hi. I have recently borrowed a car from my brother that was in the shed for some time. I have managed to get the car running and idling but when i try to drive it it craps itself. When i put my foot on the accelerator the engine dies but doesnt stall. It also pops from the air filter. Help anyone.... Thanks

I have a 91 Mitsubishi Eclipse GSX Turbo AWD and it will start but wont stay running if someone had some advice so i could get it fixed i would appriciate it.
Oh and it is an electrical problem and if i dont take the battery cables off at night then the battery will be sucked dry.

Does anyone have a copy of the workshop manual for 94 v3000?

I need the wiring diagrams so if you could scan and email or photocopy and post I'll hook you up with $10.

Ok, my friend is going to put a 354 in his monte carlo ss for christmas. he said he would give me his old engine(305 v8) would that fit in my mirage, cu zif so that would be ******* awesome! if it can im guessing i would needa new transmission..if anything else or if impossible please let me know. default/wink.gif' ...

wats good yall! i was wondering if any 1 knows about the instrument lights bc my out side lights work but the instrument cluster and the night alimunitation lights dont work. if u no any thing about it plz help!

I picked up a 1991 eagle 2000 gtx from a friend of a friend. The car needed some TLC and a valve job (which is now done)
Anyway. I can't seem to find any information on this car. I searched the net, but couldn't find anything. The only thing I know is that there were very few of these cars sold in Canada, and the cars counter part is a mitsubishi Gallant. Any info would be great.

i have a 2005 european colt and the dashboard always ratling. did any one has Structure manual?or any one with this proplem?

Hey y'all

I drive a 1995 Chrysler Lebaron. I know ur wonderin "why are you here?" Well, chrysler offered a 4cyl and 6cyl option with the lebaron, and the v6 they used was the mitsu-made 6g72 SOHC 3.0L. I like my car, convertibles are always fun, and it has good power and is pretty quick. I love the engine, has a nice tone to it.

Its gettin a lil worn tho, esp...

bought a 1994 diamante wagon cheap...runs great, in great shape. my problem is i dont have the manual...and i dont want to pay for what i need. im only looking for a diagram, or definitions of, what console indicators are for what warning. some seem vague to me...cant tell if im getting a low battery indicator meaning a new alternator. can anyone help?

can anyone tell me where the oil level warning ligth snesor is on a 1991 eci 3000 v6 shogun,not the oil pessure sensor but the level sensor,this yellow warning light comes on after about 3mins of running

greetings from a newbie. Will be spending time on this forum's past posts to get some insight into problems w/ my 93 Eagle Summit. I have had some problems lately w/ cross threaded lug nuts snapping off. The local grease cretin over worked his HD air wrench I'm sure. I have replaced 3 of the studs so far...a RPITA. Is there a source for wheel studs that are harder steel than OEM? Have...

Hi all I got a Nimbus ( Space Wagon in the UK I think ) and I just stufft up my Counter Shaft Belt, got eaten by the Timing Belt. Now I can't find the Timing Marks to put it Back to getter again Can Any body Help ????? More than Happy to buy you a BEER ! default/sad.gif' 'sad.gif' />

entirely short of any performance but definitely an eye-catcher wherever i go! yes, this is (one of) my car!!! default/57.gif' '57.gif' />

MMC MINICA TOPPO the k-car!

i would like to convert my 4g92 sohc to dohc, i was wondering which dohc head that can suit the best in my 4g92 sohc.. and what others part that i need to change..
thanks default/thumbsup.gif' 'thumbsup.gif' />

Hi guys,

this is my firsst posting, I just bought a 1985 short wheel base Pajero, due to missing, the mechanic tells me that a valve has broken or jamed,, The engine is a 4G54, is the sigma 2.6 and TE magna 2.6 are the same engine? can I replace it with the sigma or the magna head cyclinder head?


thanks

hi guys ,
I do have Dion 2.0 4G63 GDI Model. 61578Km
Car is running only with 2 cylinder, before this everty thing run good, but only the aircon gas is drain or finish.
One morning my father step on accelerator padel a little bit more(not on the move or Neutral), the the engine rpm raise up and (something wrong ...

Where can I buy tie rod boots - I hope it ´s the correct word - for my Mitsubishi Nimbus UC 1990. Mitsubishi told me my model is not any more in the computer. I Must go to Auto Barn or somewhere else. The rubber right side of the power steering is wrotten.
And remember I am living in Australia near Brisbane.

Maybe later on I ´ll have some more questions.

Thanks...

Hello guys, I am going to change my original 4G32 1.6L engine carb to a Weber 32/36 one, so I need to know the best jetting for this one...

The engine is fully stock, only exhaust tubing modified and MSD ignition installed...

Thaks for your help... The car is for autocross and street use, and I don't care for gas mileage... ...

Hello guys, can someone help me: I need to change my rear camber adjustment of my Cordia GSL. I am using it to race autocross.

I have to modify it with something easy, I can't use any Camber/Caster aftermarket parts...

Thanks for your help... default/liebe011.gif' ...

Hi ! I am trying to find some info on this 1990 Mitsu mini - Dump Truck - its a super small vehicle - and its has a governor that allows it to only go 25 MPH.

I am trying to find out if its carburated - or TBI Injection - ans also how to adjust the governor to around 35 MPH I use it on a large farm.

Where can i find parts for this thing as well? I have done some...

I rebuilt a Solex Mikuni carb on a 1980 Dodge D50. Did this about 6 years ago with no problems. Now there isn't any gas getting to the barrells. There is gas getting to the bowl but that's it. In rebuilding could I have put a diaphram in backward and if so which one would it be? In the mornings is when this happens. I can dump gas in the barrel to get it started and it will be ok the rest...

hello one and all,
I have just recently aquired a 1998 mitusbishi express SJ MWB van. Top van, drives like a dream. Anyways, It came fitted out with an alarm/immobiliser system already installed, the thing is though that the immobiliser side of the system is not hooked up. My problem is im having a little trouble finding the fuel pump and starter motor wires to patch into the alarm system. I...

Hi all,

Looking at getting a Mitsi Express for a second veichle, own a 5 litre Commodore wanting something just a bit cheaper to run around town in default/blush-anim-cl.gif' 'blush-anim-cl.gif' /> . I would like to put some Rims of some type on it, what are my options...

screen freezes when turned on and all buttons not functioning:radio buttons,tape buttons and tv buttons for 2000 Mitsubishi Cedia SE-R.Does anyone have the manual for radio,tv and CD.

would much appreciate if ny 1 can help me out with this convert, got tha 63 in the cordie no probs nd all was sweet with small cooler nd a microtec lt8s, not long afta though fuel pump carked it nd engine was struggling to idle, whilst replacing with vl pump had a custom fuel rail sitting about out of previous evoIII nd intake plennym to go with, went in sweet nd pump was workin fine...

hi gals/guys
new to the site but not to the scene
im soon to open a company that will be machining & fabricating
a long list of aftermarket goodies.

if anyone is interrested please email me for more information
and a list of parts that my company will be producing,for
cars like rx7,200sx,240sx,carollas,supras,280zx,300zx plus many more
to follow.

default/dry.gif' 'dry.gif' /> hi all
I have a 82 plymouth sappro that runs good, body has some rust and will be parting out. I want to take the engine and in stall it in to 87 dodge D-50 that body is in very good condition, all have 5 speed. I will use the same intake and exhaust system...

Just bought an old 1990 mit ute 2wd and have discovered cooling probs. Any suggestions (I only know a little about cars)

hi my Finacee wants to add some mods to her car it is a mitsu mirage 2001, If any one can help what mod i can gift her, not cheap and not so much castly.
Looking for your helpfull suggestions

If anyone is experiencing an engine rumble that reaches a pitch,creates a vibration,doesn't change with any sort of fiddling ie timing adjustments, throttle manipulation,but is most noticed on start up and above 2000 rpm and changes little with load, check your crankshaft pulley for being loose or damaged.
Bent,(Sounds somewhat like main bearing rumble but not quite)
Grooves for V...

Hey guys and girls
I have a backfire on me cordia turbo GSR in 2nd and 3rd under hard load can anyone out there help
Please email me at madaz_rules@hotmail.com
Thanks
Regards Tim

I have a 1992 Dodge Ram D50 Pickup truck ( a Mitsubishi truck mfgd for Chrysler). One of the headlight relays has conked out. Can anyone tell me where I could purchase a new relay? Have searched the internet for hours with no luck. Wally Cencich

Looking for a wiring diagram for 1992 dodge d50 2.4 pickup - Wally Cencich - wallyc@teus.net

Anyone know which is the wire that needs to be earthed to prevent the computer from advancing the timing Mitsi V3000 executive sedan 1991 New Zealand. default/rolleyes.gif' 'rolleyes.gif' />

Hello,

My name is John and I'm new to the list. I have a question, I own a 1988 Mitsubishi pickup and it just turn 200,000 milles and when that happen the maintance required light can on. Does anyone know where the reset switch is. If you would please email me at krypto@vic.com

Thanks
John

new maft clean connections not airflow signal. and red led comes on and flashes once. ?

Hi,
My brake lights have expired and I'm having trouble working out how to access the housing. Surely there's any easy in that doesn't involve removing interior trim? Hope someone can help. Thanks
Michael