Don't get me wrong when my Outlander works well I love it, it's the best riding vehicle I've ever owned and I've had 17 GMs from Citation to S10's and full size chevrolet. But it seems to me that suspension parts keep going bad prematurely on my Outlander. It was wearing tires inside in the back had to replace dogbones now it's wearing tires inside in the front and both...

Hi everyone, well my question is does anyone know if the Airtrek Rear Assay will fit on a regular Lancer 1994. I have a Fwd lancer and i would like to set it to a Evo III, is it the same suspension setup?
Does anyone have any spec drawings of the rear assay for the Airtrek? I will change the engine and the gearbox with the rest of the rear suspension.

Than ...

Hello! I recently got these H4 bulbs which I was going to put in my Outlander. Upon further inspection, I find out that these bulbs don't fit with the plug!

So I was wondering, what do I have to do to fit these H4 bulbs into my Outlander?

Thanks! And hope you can help! default/thumbsup.gif' ...

Hi guys!
I am after chrome set for my Outlander 2006. This includes side mirror cover, door handles, headlight cover, tail light and fuel tank lid cover. Anybody knows where to get them online and stores?
Thank you.

does anyone have a pic of a 1st Gen outlander with additional spotlights (after market or OEM) on the front?

thanks

Alright guys this is something new I am trying. Like the title says its a contest that will be voted on by your peers on this forum.

Follow the link read the instructions and I'll do the rest.

I hope to see all of you participate.




~Eric
EMC 3000GT...

Just wondering what people were getting per liter or gallon?

So far my outie is performing a little under for what is rated for....im getting 6.6 litter per KM or 15.7 mpg?

What are some things to improve the MPG that have to do with the engine.....or car itself....?

thanks

Since this seems to be an Int'l Forum, just wondering if anyone has any information on availablity of any aftermarket (beefier) Sway Bars aka Stabilizer Bras aka Anti-Roll Bars?

The OEM items seem like token stuff... so wimpy... only about 10-12mm thick (guesstimation, I didn't actually measure it)

I reckon before I start to do suspension mods, controlling the...

How do i disconnect the daytime running lights in a 06 outlander. I cant figure it out...

Has anyone put a Evo engine into a 1gen outlander ?
also has anyone installed a Super AFC2 into a US spec outlander?

I thinking of doing the swap. but worried about the computer problems, plus the evo has a chip in the key for theft reasons. so, im thinking i will need a complete donor car to make this work.

any input from u guys and girls...........

thanks...

Hi,

Does anyone know the specs of the Airtrek turbo?

e.g. the turbo on the Evolution 7 GTA is:

Turbo = TD05-15GK2-9.0T
Nozzle Area (cm2) = 9.0
Turbine = Inconel (steel alloy)
Compressor = Aluminium, 65mm wide

and on Airtrek:

Turbo = ???
Nozzle Area (cm2) = ???
Turbine = ???
Compressor = ???

I've...

yow wad up every one ... i'm from Jamaica and i just purchae a mit Airtrrek tubo r... i need to find out if there is any one out there that can tell me about the different types of modification that can be done to it....

Hey there!

I just found out that I have a leak in the front left CV axle. I'm told it costs $800 for the part. Has anyone else had this issue with an Outlander?

Thanks!!

I have Mitsubishi Outlander 2003. Sometimes my fans turn off making my engine overheat. I would like to know is there is a recall on that by Mitsubishi. If not, I would like to know where I can buy the fan engines. I live in Puerto Rico (USA), so it have to ship here. Thanks...

Hi, when I put on my emergency brake, it goes all the way up to the console. Anyone know how to adjust it? thanks

06 Outlander

Is it possible to fit a towbar to a 1993 outlander??

grtz
Arjan

Hello all,
I owned an Airtrek Turbo (2003) for about 5 years already. So far problem free. Just need regular oil changes, ATF changes, tyres etc. The car is JDM spec,. meaning max speed is limited to 180 km/h. Recently I removed the speed cut, by reprogramming the ECU. The car can go beyond 180 km/h. But the speedometer only indicated max about 190 km/h. Is there any speedometer (European...

Hello new to the forum but own my 03 outlander for almost 5 years now.
Great car never have a problem with anything until now.

Recently had my front brake pads and rotors change and everything seem fine until about a week later the brake starts to make a very light grinding nose with a bit of squeal everytime brake is lightly applyed whening coming to a slow complete stop.

Hi all, just got my outlander its a metalic blue / gun metalish grey XLS 2003 with 29k miles- local mitsu dealer just did the fan controller recall and that took care of my fans being on after I turn the car off.

They did an inspection and it passed everything- the trans fluid was just flushed and replaced they said- recommended a fluid flush on breaks and steering (why... from my exp...

Could you pls confirm the time and km intervals between the routine service around Europe?

In Greece ie as per Service book should be done every 15,000 km or per year whichever met first.

Talking abt outlander turbo ONLY.

My Outlander came with Yokohama all season tires (225/60/R16). I would like to buy winter tires, my question is: Do I need to buy only this size or Can I put another type (size) on my Outlander? Thanks!

Hello
I own a 2005 Outlander 2.4 AT.
I have an RPM cut and when I enter the RED zone in RPM the engeen cuts.
Is this something that all Automatic 2.4 outlander do?
Does anyone know if I can disable it and how?

Daulfin

The owner's manual on my 06 SE Outie calls for adjusting the vlaves at around 30k miles or whenever is necessary. I have had the car for almost 2 years now, and have always changed the oil on a regular basis, 6k miles Mobil 1 Full syn 5w30, and OEM oil filter. (I know this is prob. too frequent) The car is not driven hard, and most of the miles are highway miles.

I pulled the...

I have a 2003 outlander. About 6 months after I bought new tires the car developed a vibration. I thought I needed to balance the tires again.

The strange thing is the vibaration is really felt when going over 60 mph. You can feel it slightly at 0-20 mph

Now a rubbing / Grinding sound has developed. It reminds me of when your brake pads are almost gone and you apply the...

Hi,

I want to build in a double din car navigation unit in my 2006 Outlander Dakar. My Outlander is standard equiped with a single din dash console. How can i built in an new double-din navigation system in my car? Is the a dash console available for double din? Or can can i simply remove the lower 'single din' bracket? This bracket is one piece with the dash console!
I...

I have a faulty torque converter. The fluid was not properly changed and fins might be damaged. The dealership is quoting me 1300 canadian....which seems like a major job.....does this seem right? Does the diagnosis seem right....?

thanks

g

Hi Outies

Apart from a few minor niggles I'm very happy with my 03 Outlander. Coming up to 130,000 kms since May-03 & no problems whatsoever!

I would like to reduce my wkly fuel bill by adding the option of LPG. Mitsubishi Aust ( local dealer) tell me that my Outlander cannot be converted (not recommended) to run on LPG.

My ideal would be to be able...

I googled the 4G69 MIVEC and a lot of upgrades came up for the Lancer that has this engine as well. Does that mean you can perform the same upgrades on the Outlander as well?

The 2006 Outlander we have when has set overnight developes vibration at 45 mph. When the 06 is warmed up on the road for the rest of the day it will not vibe at all. Ok I here the calls now it's the tires , It's the tires , *** Nope *** The dealer has replaced the tires twice with new tires once Goodyear then Cooper orginal tires are Yoko's. The dealership is giving up on us thinks we...

My Mitsu dealer informed me that to keep the warranty I must have the tranny fluid flushed and refilled every 30,000 miles and this is not covered in my free maintenance coverage. Tranny fluid used must be factory made SP3 Diamond not available any where else except dealer. Is this correct?

Has anyone had any luck finding a Chilton or Haynes Manual for the 2003 Outlander?

Yeah, I know Good and car dealers don't naturally belong together but perhaps some of you might know of the few rare ones.

Ok, when you're done laughing do post if you know of a good Mitsubishi dealer in the DFW area. I'm in Coppell (just NorthEast of DFW airport) but will travel to surrounding areas to shop. I'm in the market for a 2004 Outlander.

Thanks.

Has anyone out there taken the dash apart to install an aftermarket stereo? If so I could really use some pointers. I'd like to move my deck over from my truck. FYI it's an '05 Outlander AWD, 5 speed. I figure I better ask before I start hacking and cutting default/grin.gif' 'grin.gif'...

I am on my 2nd 2003 Outlander LS with AWD. The first was wrecked and totaled, but I love the car so much I got another. Both cars had the same problem that I have just accepted as normal. After the engine heats up, the air blowing from the air vents is very warm, as if I had the heat on. This is an issue when dirving on a nice day when I want to have the windows down and the AC off. when the xcar...

Considering there are more than 3 or 4 Outlander turbo owners in Greece noticed so far, I wonder if we could meet each other for further discussions reg our beautiful ladies!

Mine came in black & owned since dec 2005.

Stathis

Hi there! I'm a new Airtrek Turbo owner - I'm enjoying the car although I am rather surprised at the high fuel consumption.
I would like to know whether any of you out there can recommend a workshop I can go to (in KL or Singapore) to boost up the power of the engine? I was told that it just requires a new "chip" in the engine management system?
Thanks!

i106.photobucket.com/albums/m250/Robuilt/IMAGE_106.jpg' />

my lil lady wants to upgrade her wheels/tires. not necessarily 24s or anything like that but whats the largest sized tire on hmmmm, an 18" wheel or so that would fit

Has anyone thought about or installed this cold air intake from K&N?


I haven't looked into the measurements yet, but I was wondering if anyone had any experience with this.

I was thinking about trying either something like this or the short ram intake from RoadRace Motorsports.


Thanks....

Hello all, I need help!!! I'm sure this would be simple if I had my owners manual, however someone broke into my vehicle and took everything. So I have my left rear brake bulb out and I can't figure out how to remove the lens. I did remove the two screws that I saw, but cover doesn't come off. What did I miss??? Is there a tab or another screw I didn't see? All...

Anyone know of any websited that offer aftermarket parts for the 1G? I dont wanna get everything from the dealership. To damn Expensive.

Hello to all, and thanks for looking.

My question(s) are as follows. I have done pretty much about 12 hours of research on this, on the interenet. I have found RPW's website, and it is impressive for support for the Mistubishi Outlander. Well, I have a Ram Air intake on the way for my vehicle, but now that my car is going to be breathing better (inhaling) I want to improve the...

Mitsubishi will reveal a concept crossover vehicle smaller than the Outlander at the Frankfurt auto show in September...
...Like the Outlander, the Concept-cX will feature a horizontally split tailgate to facilitate loading and unloading...

Another Mitsubishi on ...

Hi All, Im from Brisbane Australia, Im looking for some parts for my outlander. Currently it has stereo, and 20" Rims looking for bonnet and front from airtrek and possible evo8 engine if anybody knows of any?

Hi all,

I was driving my 04 Outlander in Sportronic shift mode and, while accelerating, clicked it down into 2nd from 3rd instead of going into 4th. (My other vehicle is a stick, so I'm used to 4th being "down.")

Anyway, as expected, the revs shot way up as the engine tried to match the wheel speed. I don't think it hit the red line, and it was only for a...

Do any of these actually produce power gains? Most of the feedbacks state that they do, however, have yet to see feedback from the outlander. Do they reconfigure the air\fuel ratio's? I know they change feedback to the computer, but aren't sure exactly what happens. Anyone have one? default/liebe011.gif' ...

I promised in another thread I would post some fuel economy stats and I Just thought I started a new post for this.

Ok I have a brand new (3 weeks old) Outlander VR-X (06/06 build).

I drove to Port Macquarie from Sydney last weekend.

On the way up and around Port I got 11.78 Litres/100KM
On the freeway back (371 KM journey) I got 10.68 Litres/100KM
(speed...

.
...The Outlander may not have won the off-road rally. But it’s more than capable of giving you some thrills on a blast down your favourite deserted back road...
.
...

Has anyone found a good aftermarket polyurethane swaybar saddle bushing to fit our Outlanders(2003-2006)Front and rear. If so could you give me part #'s and brand. I think I found some for rear made by Prothane (311-19-1115) 16mm it is being verified by dealer to see if they will fit. But my real problem is the front ones where I beleive they are 26 mm but I can only find 25 and 27 mm...

Hi all,

Can you buy a rear bumper protector for the outlander.
I'm after something similar to the forester part

ie:





Many thanks

Kevin...