Welcome Guest ( Log In | Register )

Mitsubishi-Forums.com > Mitsubishi Models > Galant Forum > 8G (1999-2003) Galant
     
Mitsubishi-Forums.com - The UNOFFICIAL Mitsubishi Community This site is NOT affiliated in any way with Mitsubishi or any of it's subsidiaries. Our goal is to provide Mitsubishi owners an information outlet - a means to communicate with other Mitsubishi owners. It is simply a community where fans and owners can get the right information for tuning, customization and general discussions on anything about Mitsubishi. You'll find the answer to almost any question about your Mitsubishi in this site. If not, simply join and ask! We have many willing expert members just waiting to answer your questions.

 
Powered By IP.Board 2.3.6 © 2009  IPS, Inc.
Mitsubishi-Forums.com is not affiliated with or endorsed by Mitsubishi Motors.
2 Pages V   1 2 >  
 Reply to this topicStart new topic

Do you like Mitsubishi-Forums.com? Link to us and help spread the word about our forum. Thanks!
> The Real Keyless Programming, These are the steps folks!
fuddus99
post Apr 24 2005, 06:57 PM
Post #1


Newbie


Group: Members
Posts: 4
Joined: 19-April 05
Member No.: 8,999
Status: Offline
Location: Louisville
Drives: 2002 Mitsubishi Galant ES
Mitsubishi keyless remote programming instructions:

Programming:

(Note: Entering new remote transmitter codes will erase all old codes.
All
remote transmitters must be programmed together.)

-Ensure ignition switched OFF.

-Access data link connector (DLC) located behind fascia.

-Jump DLC terminal 1 and ground.
(Note: Terminal 1 may also be grounded using diagnostic equipment connected to the DLC.)

-Within 10 seconds: Press hazard switch six times.

-Doors should lock and unlock to confirm registration mode.

-Press and release remote transmitter LOCK button.

-Within 10 seconds: Press remote transmitter LOCK button twice.

-Doors should lock and unlock to confirm registration.

-If registering additional remote transmitters, within 1 minute: Repeat button procedure for each remote transmitter.

-Doors should lock and unlock to confirm registration.

Note: To exit programming mode: Remove key from ignition or remove jump lead.

Note: A maximum of 4 remote transmitters can be programmed.
Go to the top of the page
 
QuoteReply
gevo
post Apr 26 2005, 04:34 AM
Post #2


The spirit of competition
*****

Group: Members
Posts: 1,330
Joined: 2-November 04
Member No.: 2,565
Status: Offline
Location: Irish...but currently in Hordaland,Norway
Drives: 98 galant(2.0) gls,90 galant(1.8) gls h/b,92 colt exe(1.3)
Is this sequence just for the galant or is it the same on the whole mitsi range?
Go to the top of the page
 
QuoteReply
fuddus99
post Apr 26 2005, 04:22 PM
Post #3


Newbie


Group: Members
Posts: 4
Joined: 19-April 05
Member No.: 8,999
Status: Offline
Location: Louisville
Drives: 2002 Mitsubishi Galant ES
This is for the 2002 Mitsubishi Galant ES. I am not sure about other models this will work with. Possibly the 2001 Galant?
Other Keyless programming instructions I have are for the 3000gt. So PM me if you need those.
Go to the top of the page
 
QuoteReply
Brian in FL
post Jun 9 2005, 07:36 PM
Post #4


Newbie


Group: Members
Posts: 4
Joined: 9-June 05
Member No.: 10,591
Status: Offline
Location: Fort Lauderdale, FL
Drives: 2000 Mitsubishi Galant ES
Is it the same for a 2000 Galant ES?
Go to the top of the page
 
QuoteReply
mittech
post Jun 10 2005, 09:29 PM
Post #5


Veteran
*****

Group: Moderator Emeritus
Posts: 1,559
Joined: 17-April 05
Member No.: 8,913
Status: Offline
Location: delaware
Drives: mitsu
yes
Go to the top of the page
 
QuoteReply
dchadd
post Jul 1 2005, 05:18 AM
Post #6


Newbie


Group: Members
Posts: 7
Joined: 30-June 05
Member No.: 11,609
Status: Offline
Location: Las Vegas, Nevada
Drives: 2003 Galant
Where is the fascia?
Go to the top of the page
 
QuoteReply
johnzenobia
post Jul 18 2005, 09:31 PM
Post #7


Newbie


Group: Members
Posts: 8
Joined: 18-July 05
Member No.: 12,632
Status: Offline
Location: duncansville pa
Drives: 2003 mitsubishi galant es
Question? I can get the galant into programming mode but the transmitters that I have ( got them from another galant, I work at a used car lot) will not program to the car. Any help would be great

thanks

JOhn
Go to the top of the page
 
QuoteReply
mittech
post Jul 18 2005, 09:46 PM
Post #8


Veteran
*****

Group: Moderator Emeritus
Posts: 1,559
Joined: 17-April 05
Member No.: 8,913
Status: Offline
Location: delaware
Drives: mitsu
Not all cars use the same remotes. Some even look identical, The difference is the manufacturer of the remote was different on different models during different years. Some are Denso and some are omron. This programming sequence will work on any 99-03 Galant or 00-05 Eclipse.
Go to the top of the page
 
QuoteReply
johnzenobia
post Jul 24 2005, 12:24 PM
Post #9


Newbie


Group: Members
Posts: 8
Joined: 18-July 05
Member No.: 12,632
Status: Offline
Location: duncansville pa
Drives: 2003 mitsubishi galant es
Finally got it to work. Thanks
Go to the top of the page
 
QuoteReply
adeshch1
post Aug 12 2005, 09:55 AM
Post #10


Newbie


Group: Members
Posts: 1
Joined: 12-August 05
Member No.: 13,943
Status: Offline
Location: Brooklyn, NY
Drives: Mitsubishi Diamante 2000 LS
Hey,

Can somebody please explain what they mean by this phrase?

"-Jump DLC terminal 1 and ground.
(Note: Terminal 1 may also be grounded using diagnostic equipment connected to the DLC.)"

and how can I do it? Thanks.
Go to the top of the page
 
QuoteReply
nyestek
post Nov 14 2006, 10:24 PM
Post #11


Newbie


Group: Members
Posts: 1
Joined: 14-November 06
Member No.: 31,823
Status: Offline
Location: Canada
Drives: 2003 Mitsubishi Galant
Hi;

I just did the programing on my 2003 Galant and your instructions worked except the part (ensure ignition switch is off), my ignition switch had to be "on". I programmed 2 remotes and they both work great. Thanks for the instructions.
Go to the top of the page
 
QuoteReply
mabsta
post Feb 5 2007, 04:56 PM
Post #12


Newbie


Group: Members
Posts: 3
Joined: 31-January 07
Member No.: 34,878
Status: Offline
Location: usa
Drives: 2003 mitsubishi galant
what can u use for a "jumper to connect the 1 and 4 terminals. my dad seems to think that a simple paper clip will work?
Go to the top of the page
 
QuoteReply
mitzi4eva
post Feb 12 2007, 06:15 AM
Post #13


Full Member
**

Group: Members
Posts: 75
Joined: 22-June 06
Member No.: 25,684
Status: Offline
Location: Travel Alot
Drives: 1991 Galant SS Lux......TWO 1991 Galant Type 1 AMG's .....1991 Galant GSX
Hey there, I have a 91 Mitsu Galant with factory keyless entry and lost the remote like 1 month ago .... with my other Galants having alarms... locking with the key drives me mad not to mention quite stressful now hehe. Does anyone know the programming routine for the 87-93 6gen Galant range? Regards -Andrew
Go to the top of the page
 
QuoteReply
aqxea2500
post Feb 15 2007, 05:24 PM
Post #14


Newbie


Group: Members
Posts: 1
Joined: 15-February 07
Member No.: 35,588
Status: Offline
Location: USA
Drives: 2002 Galant ES, 2006 Kawasaki 636
QUOTE(adeshch1 @ Aug 12 2005, 08:55 AM)
Hey,

Can somebody please explain what they mean by this phrase?

"-Jump DLC terminal 1 and ground.
(Note: Terminal 1 may also be grounded using diagnostic equipment connected to the DLC.)"

and how can I do it? Thanks.
[right][snapback]25985[/snapback][/right]



Yeah I need some more info on this also.!
Go to the top of the page
 
QuoteReply
kpineda3889
post Mar 26 2007, 11:31 PM
Post #15


Newbie


Group: Members
Posts: 1
Joined: 26-March 07
Member No.: 37,446
Status: Offline
Location: USA
Drives: 2002 Mitsubishi Galant ES
hi i was wongering if you ever find out what "-Jump DLC terminal 1 and ground.
(Note: Terminal 1 may also be grounded using diagnostic equipment connected to the DLC.)" meant? if so can you please let me know and how to do it. Thanks
Go to the top of the page
 
QuoteReply
BAlexandrov
post Apr 9 2007, 12:27 PM
Post #16


Newbie


Group: Members
Posts: 3
Joined: 1-July 05
Member No.: 11,680
Status: Offline
Location: Sofia, Bulgaria
Drives: Mitsubishi Galant E52A
Ground is on pin 4 so you can connect pin 1 and 4 or somewhere on chassis
Long side
_____________________
Pin 1 -> \ | | | | | | | | / <- Pin 8
Pin 9 -> \ | | | | | | | | / <- Pin 16
-----------------
Short side
Go to the top of the page
 
QuoteReply
pgroom
post Aug 18 2007, 12:49 AM
Post #17


Newbie


Group: Members
Posts: 1
Joined: 6-January 07
Member No.: 33,713
Status: Offline
Location: Australia
Drives: Verada
If you want to reprogram a remote key for a mitsubishi magna or verada you can follow the instructions here.
Go to the top of the page
 
QuoteReply
costadragon220
post Oct 1 2007, 04:25 PM
Post #18


Newbie


Group: Members
Posts: 17
Joined: 1-October 07
Member No.: 45,921
Status: Offline
Location: South New Jersey
Drives: 2000 Galant ES


:grouphug:
Go to the top of the page
 
QuoteReply
jf2k
post Jan 21 2008, 02:07 PM
Post #19


Newbie


Group: Members
Posts: 1
Joined: 21-January 08
Member No.: 51,277
Status: Offline
Location: USA
Drives: 2002 Galant



Same for me. Make sure ignition is "ON".
Worked like a charm. :banana:
I wasted 15 minutes trying to make it work with ignition off.
Thanks for your posting.

By the way everyone. A paper clip will work for connecting pins 1 and 4.

Peace!
Go to the top of the page
 
QuoteReply
eron_cam
post Feb 6 2008, 12:02 AM
Post #20


Newbie


Group: Members
Posts: 8
Joined: 4-February 08
Member No.: 52,078
Status: Offline
Location: Florida
Drives: 2003 Mitsubishi Galant ES
so i tried both ignition on and ignition off... with a paper clip attached to lead one and four. and followed the pressing instructions as many different ways possible. but still no luck!
maybe i need a lil more clarification....

ignition on or off BEFORE or DURING?

PRESS the hazard button six times,
or
TURN ON the hazard button six times?

when its stated to press the buttons with __ seconds or __ min, does that mean press the button and wait til the __ seconds is passed from first pressing, or just get it done within that time?

what would be recommended to connect port 1 to 4 with, instead of a paper clip?
Go to the top of the page
 
QuoteReply
  Advanced Search
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

2 Pages V   1 2 >
Reply to this topicStart new topic
Get your Mitsubishi listed in the Garage Today, for FREE, to share with the world what you drive and what toys and modifications you have.

Collapse

> Similar Topics

  Topic Replies Topic Starter Views Last Action
No new The Quest For 100,000
 542 EMC 3000gt 2,642 Yesterday, 06:42 PM
Last post by: SRSONE
No new The Best Floor Mats?
 34 russlancer 312 10th November 2009 - 03:50 PM
Last post by: youngmasterzack
No New Posts There Is A Summit Awd Donor Car In Classifieds
 0 PCweber 39 10th October 2009 - 10:47 AM
Last post by: PCweber
No New Posts The Spirit Of Evolution
 23 DuffmasterFresh 689 1st October 2009 - 06:34 PM
Last post by: stardust
No New Posts The Galant Gdi Is In A New Garage
Please read topic "rough iddles, misfires, etc."
 0 Spirosgalant 31 17th September 2009 - 02:36 PM
Last post by: Spirosgalant

 
 
 
Time is now: 21st November 2009 - 10:08 PM
(c) 2004 Mitsubishi-Forums. All rights reserved.
Mitsubishi-Forums.com is not affiliated with or endorsed by Mitsubishi Motors.
Privacy Statement