Hi all.

I have fitted a tow bar to my 1992 Import Pajero (UK). I am in the process of fitting the wiring kit (Lights) and need some advice as its been a number of years since I have touched one of these. (Had one about 9 years ago and installed same on that).

My main question is, where is the best place to pass the wiring up from the underside of the vehicle and is all the wiring connected on one side of the vehicle. I vaguely remember in the past wiring into one side only (but I could be wrong on that - bad memory). I have all the snap connectors etc so once I have located the main wiring for the rear lights the rest of the job should be easy.

Thanks in advance

Si

Si,

Your should be able to feed the cable through the underside of the car roughly above the exhaust, just behind the bumper.
You can attach all wires to the cables going to the drivers side light cluster. If memory serves me correctly loosen two screws and the light cluster will pull out to allow access.

Les

Thanks Les. That fits in with what I remember, I had the unit off this afternoon checking the wiring out.