This is my first of many posts...I hope

Does anyone know where to get an OEM fog light kit for a 2006 Ende...all I can find is for 04-05. I have not contacted the dealer I would guess he could get them.

You're correct about the dealer as a source. They quoted me $125 for the kit, which can be installed by the owner (should you want the dealer to install it, labor is not included in the price). Were you able to find a lower price on the 04-05 light kit?

This site has the fog light kit that will fit the 04 and I assume the 05 as well
Mitsu Parts I do know that it would be a waste for the dealer to install since it is pretty much just a plug it in a go. If you pull the plastics out where your lights go you will see that they are already wired up and ready to accept lights. Thanks for the help.

Tony

I wouldn't try one that just fits '04 because that year had a square hole and the newer endeavors have a smaller round hole. It might fit, but is it worth taking a chance for $10 less? (Thanks for the link, though...)

I bought them from the dealer. They came with the switch and all. Everything snapped into place very easily. It took me 15 minutes from start to finish.

My Dealer in town told me that they can't get them yet...This would also be the reason way I didn't buy Ende from them. They seem to be alittle (or alot) slow.

I will try to call them again.

Yeah, I have to agree not to get the 2004 foglights if you have a 2006 Endeavor. When I went to a nearby after market store to pick up PIAA bulbs to replace the stock bulbs on my 2006 Endeavor. The dude @ the store gave me H1 bulbs because that's what the PIAA specs gave out. It was not until the Mitsu dealership went to install the bulbs I was then told that the bulbs are different. Apparently, the 2004 & 2005 Endeavor foglights uses H1's. But the 2006 & I'm assuming the 2007 uses H11 bulbs. So I'm pretty sure the fitment between the 04 & 05 is different from the 06+.

Good Evening, Tony,

Are you saying that the recepticle for the fog light kit is already there and you simply remove the extant plastic grating, plug in this kit, run some wires and voila! it is done?

That sounds easy as pie!

-Dreadnought

This maybe a late respond...but yes the fog lights are just a plug everything in and go. I did this for my 06 and it took about 5-10 min.

Easy to do and makes a very nice improvment. Plug lights in....plug relay in...plug switch in...and drive.

I bought them for my 06 from the dealer and they took me 15 minutes to install. They come with switch and all.

Ok, stupid question...How do you pull the plastics out where the fog lights go? The switch was a piece of cake..Thx...

Jameo

just pry it open hard. it will pop off.

I broke one of my tabs, any idea where to get a new plastic housing ?