Hey all I want to make a push button starter, I took some pics of the ignition, this is the pic of the wires, how would you go about this?
(IMG:http://natoari.com/files/27112007126.jpg)http://natoari.com/files/27112007125.jpg and (IMG:http://natoari.com/files/27112007125.jpg)

just use a volt meter to test which wire off the ignition switch is "hot" when cranking. then simply cut that wire and attach the end not attached to the ignition switch to your push button switch.the other side is just a 12v battery feed.you may need to extend the wires depending where you wish to place the switch.also make sure the switch you use is strong enough to carry the amount of current you will put through it.of course by doing this you will still need the ignition turned on in the run position to start the vehicle.hope this helps a bit