Hi,

I bought the mitsubishi's kit for my L200, 1999 (model K74T). The kit also works on a Pajero Sport. The kit's reference is MZ312043. I successfully installed in a wiring. I tested with remote controls, and this was only the flashing light up (the warning), the doors of not moving. With the key that did not work either. I then moved the switch on the box 'on' and I tested again, it did not. So I handed over the switch to 'off' as i received it. Now, closing with the key works (like without box), but the remote control are no longer walk the flashing (the warning).
It is as if I had removed the link between remote and box (erase the assignation)...
Therefore, I am looking for the instructions of the kit to redo the link between the remote control and the box.

I tested the technical manual handling:
- Connect the pin 1 (it is writting very small on the connector) from diagnostic connector to earth (to the car body)
- Put the boot on contactor (start contactor) 'On' 1 second, putting it on 'off' 1 sec, three times in a row, but normally the doors should open and close, but they do not
Contactor put the boot on 'on' means turning the key in the first step (radio that lights up) or the 2nd screen (scoreboard lit)?

Thank you!