This is directly copied from http://forums.evolutionm.net/showthread.php?t=288120 posted by Jake26. All credit goes to him. Don't know him, but I hope he won't get mad at me (IMG:style_emoticons/default/bwekk.gif)

Front of car:
Front turn signal light: 21watts bulb: WY21W
Head light, high beam: 60watts bulb: 9005 HB3
Head light, low beam: (halogen bulb) 51watts bulb: 9006 HB4
front foglight: 55watts bulb: H11
Front side marker and parking light: 5watts bulb: 168/194
Side turn signal light: 5watts bulb: 168/194


REAR of car:
High mounted stop light: Led
License plate: 5watts bulb: 168/194
back up light: 21watts bulb: 7440
tail light: 5watts bulb: W5W
tail and stop light: 21/5watts bulb 7443
rear turn signal: 21watts bulb: 7440
rear sidemarker: 5watts bulb: W5W


INSIDE CAR
trunk area: 5watts bulb:----- 3022
dome light: 8watts bulb:----- 3022

Do you know what bulb(s) go into the light directly above the ashtray/AV input area?

U MY FRIEND ARE A LIFESAVER!!!!! been longing for these specs everywhere, but the car is too new so no one has any info on it!

Now open the dash, and see if we can change the instrument cluster lights! lol

just one question, i want to chage my drl lights to led is that possible?
and also what size bulbs are the drl's?

your drl's are your low beam headlights. you cannot put in LED lights. the way ur drl's work is that the low beam lights run at a lower voltage so they are dimmer, then wen u turn ur lights on the the amount of light is brighter from more voltage. :P . the only thing u can do is put in hid xenons, but then u risk them flickering when your drl's are on because they cant operate with the low voltage.

there is other threads about the flickering aswell, just search it.

question are the city lights that are on the very outside of the headlight these?.... Front side marker and parking light: 5watts bulb: 168/194

That's right.

Took me long enough to reply. Sry.

They are micro LED's that are soldered directly to the wire board (or whatever the term for that was, I forget now) that controls the air settings. Pretty hard to replace. Not impossible though! I'll git er done some day.

 wireboard.jpg ( 70.32K ) Number of downloads: 62

Ok so I didn't open the dashboard, but I will assume (seems pretty safe to do so) that the LED's are also micro LED's soldered to a wire board as well.
That would make sense, since everything else I have seen so far (air control panel and the stereo unit) are all micro LED's.

Those arent too shabby to switch out. They are probably 9006 LED's. Dont quote me on that but that is a common SMD type LED. I wish this wouldnt void my warranty since I have a mess of new 9006 LEDs in a bunch of colors. Oh well.

Not bad to take out with a decent soldering iron. I picked one up a few years ago for like 10 bucks... it's no good...
I actually got a lot of training on soldering back at school but we had some pro equipment for that: Weller soldering stations - those are SICK. But that type of stuff would run me a couple grand or more for the setup - OUCH.

It would be nice to swap those out though with proper equipment. Easy mode that not a lot of people would have (IMG:style_emoticons/default/biggrin.gif)