Mitsubishi-Forums.com is not affiliated with or endorsed by Mitsubishi Motors.
Do you like Mitsubishi-Forums.com? Link to us and help spread the word about our forum. Thanks!
 New Day New Problem :(, car lost power to wheel now won't strt.. |
|
|
|
|
 Feb 9 2008, 05:42 PM
|
Member
Group: Members
Posts: 35
Joined: 23-November 07
Member No.: 48,382
Status: 
Location: Memphis, TN
Drives: 1996 Eclipse rs
|
QUOTE(JuGs @ Feb 9 2008, 05:32 PM) could be ur starter if it just sounds lik a free spinnin thing ur cyilanoid might of went bad and its not lettin the starter fully engauge with the flywheel
[right][snapback]141344[/snapback][/right]
So if a starter goes bad while your driving the car would that cause it to suddenly loose power at the wheel while the car is still running? Cause if its just my starter that shouldn't be to big of a problem. :)
|
|
|
|
|
|
|
|
Feb 10 2008, 10:31 AM
|
Member
Group: Members
Posts: 35
Joined: 23-November 07
Member No.: 48,382
Status:
Location: Memphis, TN
Drives: 1996 Eclipse rs
|
QUOTE(waynerwats @ Feb 10 2008, 05:02 AM) i had my timing belt tensioner and idler pulleys blow up on me, but my car would try to turn over normally. I was doing about 60 and all of a sudden the car was running (badly and not for very long) with no power. the timing belt wouldnt turn while cranking the engine (which i dont recommend because its an interference engine).
I dont think its your starter. while your car is running your starter doesnt do anything. unless you have a manual (i didnt see you say that you had one) your flywheel shouldnt be the issue either. if you do and your clutch blew up it should move a little but not much and not very fast.
If you lost power to the steering wheel while the engine was running then there would have to be a problem with your ps pump or something related.
check to see if your timing belt has any tension. if it does then im sorry i dont know what your problem could be unless your timing belt skipped a tooth or more. if it doesnt have any tension thats your problem.
[right][snapback]141434[/snapback][/right]
No I don't have manual, my power steering pump works, Don't have tension in timing belt and when I say I lost power/pull it was like my trans went out at once every gear was neutral(all it did was rev didn't matter if I was in D,R,1, or 2) but that can't be it cause if the trans died it should still start...
|
|
|
|
|
|
|
|
Feb 10 2008, 11:41 AM
|
Member
Group: Members
Posts: 35
Joined: 23-November 07
Member No.: 48,382
Status:
Location: Memphis, TN
Drives: 1996 Eclipse rs
|
QUOTE(Lewiman06 @ Feb 10 2008, 10:58 AM) if your tranny is bad, you'd still have wheel power and it would still start. it couldn't be electronic could it? i can't see what would make the wheel and starter not work? and aren't you supposed to have tension in the belt?
[right][snapback]141463[/snapback][/right]
Its not the timing belt cause the car was still running when it broke if it was anything with the timing belt it would a should a stall out which it didn't I cut it off after it wouldn't go anywhere and a weird noise started getting loud under the hood. And my brother had a Buick and the tranny went bad but it still drove till each gear just grinded away. Idk its weird to explain guys it was like a drive shaft falling from under a truck it'll rev but it won't go anywhere but now my car won't strt. Sounds like a drill or a blender on low when im trying to crank it like its turning freely...
|
|
|
|
|
|
|
|
Feb 11 2008, 05:59 PM
|
Member
Group: Members
Posts: 35
Joined: 23-November 07
Member No.: 48,382
Status:
Location: Memphis, TN
Drives: 1996 Eclipse rs
|
QUOTE(Yahn @ Feb 11 2008, 12:31 PM) Maybe your timing belt slipped.... Just happened to me the other night, bent a few push rods.... I had no power at the wheels or anything when i was driving home with it, but does it sound like you can hear your pistons hitting the valves or something like that?
[right][snapback]141703[/snapback][/right]
Before I turned it off it sound strange don't know if it was a piston or valves...but now it won't start so I can't even get a clue of what happen. And my timing belt is still there looks just like its always looked.
|
|
|
|
|
|
|
|
Feb 11 2008, 06:07 PM
|
Member
Group: Members
Posts: 35
Joined: 23-November 07
Member No.: 48,382
Status:
Location: Memphis, TN
Drives: 1996 Eclipse rs
|
QUOTE(n3w2carsc3n3 @ Feb 11 2008, 01:56 AM) Sucks
[right][snapback]141651[/snapback][/right]
I know just got it fixed a month ago 200 bucks for a burnt wire guy at the shop never told me where that expensive wire was just kept saying how late he stayed finding it and how it was some where under the hood <_<
|
|
|
|
|
|
|
|
Feb 11 2008, 06:10 PM
|
Member
Group: Members
Posts: 35
Joined: 23-November 07
Member No.: 48,382
Status:
Location: Memphis, TN
Drives: 1996 Eclipse rs
|
QUOTE(waynerwats @ Feb 11 2008, 09:35 AM) well what i think happened with my car was one pulley blew up (probably the idler first) and the car still ran but badly (like it was missing) and the CEL came on. on my way to have the code(s) checked out (now i have a code reader here at the house) i think the tensioner pulley gave out and that was the end of it running.
[right][snapback]141687[/snapback][/right]
I was thinking of buying a code reader there pretty cheap on ebay. :)
|
|
|
|
|
|
|
