OK.....so i got the front 3 motor mounts swapped out with the Solid mounts. Transmission side, Front, and Belt side mounts. All done with those. But the rear mount.....wtf?? is there any special trick or anything to get to this? because theres a LOT of sht in the way and by the looks of things, it seems to be impossible to swap out...



As for the underdrive pulley....what do i need to do go get the crank pulley off and get the underdrive pulley on there..? i have the belt for the underdrive so thats not a problem..but what do i need to do to get the pull off?

HELP!!! lol



Eric

HAHAHAHAHAHAHAHAHAHAHAHAHAHA

oooph. have fun with that mount. Just be happy you have a nonturbo.

Look at the pulley you have three holes, one has the nut, which you can use a half inch drive socket with no socket. and then the two on both sides. You need a tool that plugs into those two holes and then lock the pulley into place.

You can make it or pay $75ish and buy it.

I made one from some bolts a 2x4 and a 2x6 or 8

And the torque on it when tightening it is 150 or 157 FT/LBS so start taking some roids friend.

Well i got the rear mount done finally!.....but i'm a stupid a.s.s. and forgot to gap the new plugs to spec so i have to take everything apart and redo my spark plugs..lmao



As for the pulley...i don't feel like fckin with it..i'll probably take it to my buddies shop and have him do it for me....he's a good friend..he'll do it for next to nothing...or a case of beer..ha