im looking for lights that fit the little round holes in the front bumper of my 03 eclipse gs. i hate how they look with those black pieces of plastic they stick in there to cover the hole
i was also gonna put lights into those "slits" (for lack of a better word) that are underneath the headlights. how would i take the plastic cover piece out of there, or do you even take it out? thanks for the help

I don't know exactly but they should just pop out or if all else fails just cut them out and try not to F-up your bumper. Or, this way is m ore expensive, but go to the dealer and ask them to put in the OEM fog lights for you and they will take care of getting those things out for you.

You apparently haven't even tried...

Remove your turn signals (a single screw)

Reach inside the bumper and squeeze on the two pieces that hold each black plastic fake vent in place and it will pop right out. Repeat for each.

no, i didnt try at all actually, just checking with the experts before i do anything possibly stupid haha
but thx for your help guys. i appreciate it!

These blackouts do not pop out, they have three screws in them that you must remove from inside the bumper, then if you plan on putting the fog lights in you need to ensure your wiring harness is set up for the lights and you will need the light switch that controls them.

some GS didnt come with fogs.(mine)
so i got HID fogs blue iceberg light headlights
Socal-hids headlights-80 :D

Where did you get those HID fogs blue iceberg light headlights and are they easy to install?

A place in Pomona.
PNP-Easier than pissing :D

AutoBacs?