the other day i start driving and the trans was stuck in safe mode, after a while it started to shift but it shift really hard so hard that the whole car jerk.
i dont kno what could cause it because the fluid still looks good and there were plunty of it.
now im just wondering what could cause it to do that

Most likely seems to be an issue with the TCM itself. Most likely as of why it wasnt shifting. When the TCM isnt powering the transmissions solenoids the valve body can onlee send clutch pressure to the 3rd gear drum. So as of why it wasnt shifting and stayed in a upper gear. But for wut ever reason when the TCM either regained power or started to function again , it started accurately reading the input shaft sensor speed and adruptlly shifted into a lower gear before it was able to vary the shift pressure.

Yu can check the fuse for the TCM in the car's fuse panel. Make sure it isnt loose or sumthing like a wire or anything isnt jointly hooked to it. In most case the TCM itself could be near totally failing and would need to be replaced.

where is the location for the TCM fuse at??
and where is the location of the TCM incase i need to change it

thanks

where is the location for the TCM fuse at?? is it under the hood or inside the car
and where is the location of the TCM incase i need to change it

thanks

The fuse should be in the inside fuse panel. It may say (4AT) , thats the fuse for the TCM. The TCM is located in the center floor under the dash , under the a/c box/under front center console.

You can buy second hand transmission computers
from car wreckers

thanks guys
imma go to the junkyard this week to look for it

oh and i check the fuse and is not blown