Hi I have a 1995 shogun2.8td.The ABS light was on constantly from the start I had a diagnostic plugged in and the front L/H wheel sensor was showing a fault.I took the expansion tank out to track the wiring and found a wire from the front wheel sensor and the insulation worn through and was earthing to the chassis.Now the ABS turns off after the self test ,however when the trigger speed of about 5mph is reached the ABS light comes back on and stays on.I have had the diagnostic plugged in again and now shows a short circuit on front L/h Sensor.I have traced the wiring back as far to the front right hand wing where it goes into the wing.Can anyone tell me where the wiring goes after this as I believe there may be a wiring fault and need to test continuity and insulation resistance.many thanks