Welcome Guest ( Log In | Register )

Mitsubishi-Forums.com > Mitsubishi Models > Lancer Forum > 2008+ Lancer > Car Audio, Video & Electronics
      Monroe Reflex Shocks
Mitsubishi-Forums.com - The UNOFFICIAL Mitsubishi Community This site is NOT affiliated in any way with Mitsubishi or any of it's subsidiaries. Our goal is to provide Mitsubishi owners an information outlet - a means to communicate with other Mitsubishi owners. It is simply a community where fans and owners can get the right information for tuning, customization and general discussions on anything about Mitsubishi. You'll find the answer to almost any question about your Mitsubishi in this site. If not, simply join and ask! We have many willing expert members just waiting to answer your questions.

 
Powered By IP.Board 2.3.6 © 2010  IPS, Inc.
Mitsubishi-Forums.com is not affiliated with or endorsed by Mitsubishi Motors.
 
 Reply to this topicStart new topic

Do you like Mitsubishi-Forums.com? Link to us and help spread the word about our forum. Thanks!
> Anyone Got A Wiring Diagram/stock Unit Removal Info On Deck Installation?
russlancer
post Apr 23 2009, 02:35 PM
Post #1


Full Member
**

Group: Members
Posts: 145
Joined: 6-September 08
Member No.: 63,898
Status: Offline
Location: Canada
Drives: 09 Lancer se
Hey guys I'm ready to install an aftermarket deck, and i'm looking for a wiring diagram. I understand that wiring harness should do the trick,
but it's always good to know what that extra pink wire with a white strip means or something like that.
Also where can I find a guide on how to remove the stock unit, plastic that it's made off is so soft that I'm scared to play around with it not knowing where all the clips and bolts are.

Thanx for any help
Go to the top of the page
 
QuoteReply
SiR Will
post Apr 23 2009, 07:00 PM
Post #2


Full Member
**

Group: Members
Posts: 226
Joined: 29-July 08
Member No.: 61,905
Status: Offline
Location: USA
Drives: 2008 Mitsubishi Lancer GTS
do a search on the web for a diagram. To remove your deck, open your glove box. Remove the screw on the right hand side. Pull the piece out the the screw was holding. There should be another screw holding the trim that goes though the middle of your dash. Remove it and pull of the trim. Next pull off your stock stereo's face panel . Disconnect the harness that goes to hazard light button and the rest should be common sense.
Go to the top of the page
 
QuoteReply
russlancer
post Apr 24 2009, 01:36 PM
Post #3


Full Member
**

Group: Members
Posts: 145
Joined: 6-September 08
Member No.: 63,898
Status: Offline
Location: Canada
Drives: 09 Lancer se
hey thnx sounds like an easy install to me.
And i pulled the diagram off the shopkey from a nearby partsource store, they have all the diagrams for free.
Go to the top of the page
 
QuoteReply
lancer08EE
post Nov 14 2009, 07:09 PM
Post #4


Newbie


Group: Members
Posts: 3
Joined: 21-June 09
Member No.: 73,731
Status: Offline
Location: USA
Drives: 2008 Mitsubishi Lancer ES
heyy. thanks for the tip on how to get the stereo out. i have a 2008 lancer es and i tried to take out the stereo just to see what it would take to put a new one in. unfortunatly i thought i had to take off the hazzard light piece. so i pulled and pulled and it came out real fast but then i realized there was a white lookin strip connected just behind where the it shows if the passenger air bag is on. one end was connected the other wasnt. so now i was like shit!!! i put it all together again turned on my car everything was fine until i looked up at the dash. the music was playing but the time or song track wasnt displaying on the little screen. also the only way i could control the music was from the steering wheel. PLEASE if you know what could have happened or where the other end of the strip could go i would really like to know. thank you very much and i hope you can let me know asap.
Go to the top of the page
 
QuoteReply
Abb
post Nov 15 2009, 03:13 PM
Post #5


Senior
***

Group: Members
Posts: 358
Joined: 3-April 09
Member No.: 69,435
Status: Offline
Location: Canada, Gilford
Drives: 2009 Mitsubishi Lancer GT
press the display button. That should scroll through. Other than that, the little strip has nothing to do with it other than the airbag lights. And it just illuminates them.
Go to the top of the page
 
QuoteReply
lancer08EE
post Nov 19 2009, 11:02 PM
Post #6


Newbie


Group: Members
Posts: 3
Joined: 21-June 09
Member No.: 73,731
Status: Offline
Location: USA
Drives: 2008 Mitsubishi Lancer ES
alright cool. im new to my lancer but where is the display button
Go to the top of the page
 
QuoteReply
  Advanced Search
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

Reply to this topicStart new topic
Get your Mitsubishi listed in the Garage Today, for FREE, to share with the world what you drive and what toys and modifications you have.

Collapse

> Similar Topics

  Topic Replies Topic Starter Views Last Action
No New Posts Wiring Woes
 4 burnout28516 38 Yesterday, 10:55 PM
Last post by: KiT TeUnG 2549
No New Posts Wiring Gremlin
Is my OBD-II Is dead?
 0 blubyu 13 13th March 2010 - 07:23 PM
Last post by: blubyu
No New Posts Anyone In The Central Washington Area?
lookin for central washingtonians
 2 Phaze3g 185 25th February 2010 - 12:56 AM
Last post by: Davefyil
No New Posts Wiring
 1 andy2b 256 16th February 2010 - 08:30 AM
Last post by: sensimilia_uk
No New Posts Anyone Want A Gts Spoiler?
 1 FastLane1000 148 15th February 2010 - 01:56 AM
Last post by: 505-richman

 
 
 
Time is now: 18th March 2010 - 06:42 AM
(c) 2004 Mitsubishi-Forums. All rights reserved.
Mitsubishi-Forums.com is not affiliated with or endorsed by Mitsubishi Motors.
Privacy Statement