Hello

Can any members tell me how difficult it is to install fog light kit on XLS 2004 Endeavor.

Has anyone done it, or can give me any input.

It would be very helpful

Thanks DS

It is very easy if you get the factory light kit all the wiring is already there.

Thanks for info, is there anything special, I should look out for.

DS

No they come with detailed instructions and should only take about 15 minutes to install.

I agree...just make sure you order stock lights from a dealer (which will come with the proper grills). I paid $120 at mitsubishipartsstore.com. It took me about 20-30 minutes to install the lights and the switch in the dash. Love em.

Just finished my fog light install as also stated here this is a easy install .Wish all up grades were this easy.



Bruce
2004 Endeavor

finally got mine installed too. and my hood protector.........

Heloo ,

i now have an endeavor LS 2005 and wish to install myself my fog lights .

I plan to use my own switch , I open the small compartment that give me access to the socket , there is 4 wires : which should be connected together ?

If someone knows just tell me either the color of the cable /or the rank starting the highest one .

I know i could purchase just the real switch from my dealer but i want to save some $.

Or best can someone email me his instruction booklet then i could figure out how to finalise it.

Email : bijou@ca.tc / Robert

Thank you.

i hope this will help but you need a relay
and actually mine is on the 3rd switch not the midle one.

I can understand your not wanting to purchase the switch, you really need it. You will also need the relay as well.

Don't try to rig a switch the factory switches are pretty cheap and fit nicely in the panel. The wiring harness is all in place and you will find that the harness should be plugged into the "dummy plug" that simply takes up space if you did not purchase the fog lights on the vehicle. The wiring for the fogs are also attached to the back of the blk grills on each side of the vehicle. When Mitsubsihi started building the "PS" series they decided to use only one wiring harness to cut costs instead of having different ones like they did for many years in the different models. The advantage for you is simplicity of add on lights. If you need to remove the grills remeber to remove the screws, then and this is very important PULL THE GRILLS STRAIGHT OUT. If you don't you will scratch the front fascia. I worked in the factory for 12 years in the light repair area. When we removed the grills we would use a plastic (magic stick) stick to pry one side out enough to grab them. If you have difficulty, put some masking tape on the fascia where the grills are to prevent scratches.

Hope this helps