Mutt 2 And 3 Fault Codes - Mitsubishi-Forums.com
 
LinkBack Thread Tools
post #1 of 1 (permalink) Old 10-21-2014, 02:48 PM Thread Starter
Super Moderator
 
chain rattle's Avatar
 
Join Date: Jan 2006
Location: Ipswich Qld Australia
Posts: 4,065
Send a message via AIM to chain rattle Send a message via Yahoo to chain rattle
this information is a correct as possible for 2014

OBD2 use on Mitsubishis depends on model and year

mutt two Mitsubishi specific

http://www.alibaba.com/product-detail/Foxw...857.35.1.NbBqKX

Mitsubishi MUTT 3 Demo Video
https://www.youtube.com/watch?v=P2qQqYCst-U


some mutt 3 units prices

http://www.obdresource.com/category.php?id...30#.VEbLNSKUe5w



12 - Air flow sensor system
13 - Intake air temperature sensor system
14 - Throttle position sensor system
21 - Engine coolant temperature sensor system
22 - Crank angle sensor system
23 - Camshaft position sensor system
24 - Vehicle speed sensor system
25 - Barometric pressure sensor system
41 - Injection system
44 - Ignition coil and power transistor unit system (cyls 1 and 4)
52 - Ignition coil and power transistor unit system (cyls 2 and 5)
53 - Ignition coil and power transistor unit system (cyls 3 and 6)
54 - Immobilizer system


Diesel Engines

11 - Accelerator pedal position sensor (main) system
12 - Boost pressure sensor system
13 - Barometric sensor (built-in) system
14 - Fuel temperature sensor system
15 - Engine coolant temperature sensor system
16 - Boost air temperature system
17 - Vehicle speed sensor system
18 - Engine speed sensor (backup) system
21 - Engine speed sensor system
23 - Idle switch (accelerator pedal position sensor built-in) system
25 - Timer piston position sensor system
26 - Control sleeve position sensor system
27 - Accelerator pedal position sensor (sub) system
41 - Main throttle solenoid valve system
43 - Timing control valve system
46 - Injection correction ROM system
48 - GE actuator (in the middle of control sleeve position sensor inoperative) system
49 - Over boost (turbocharger waste gate malfunction)
54 - Immobilizer system


This uses the A/T oil temp warning light.

A/T Error Codes (3.5L 6G74 only)

11 - Throttle position sensor system (malfunction of sensor Open or short circuit)
15 - Oil temperature sensor system (Open circuit)
16 - Oil temperature sensor system (Short circuit)
21 - Ignition signal system (Short circuit)
22 - Ignition signal system (Open circuit)
23 - Signal line from ECM to TCM (engine coolant temperature signal line) (Open circuit)
24 - Signal line from ECM to TCM (Engine coolant temperature signal line) (Short circuit)
29 - Park/neutral position switch system (Short circuit)
30 - Park/neutral position switch system (Open circuit)
31 - Input shaft speed sensor system (Open circuit)
32 - Output shaft speed sensor system (Open circuit)
41 - Shift solenoid No. 1 system (Open circuit)
42 - Shift solenoid No. 1 system (Short circuit)
43 - Shift solenoid No. 2 system (Open circuit)
44 - Shift solenoid No. 2 system (Short circuit)
47 - Lock-up solenoid system (Open circuit)
48 - Lock-up solenoid system (Short circuit)
49 - Torque converter clutch system engagement problem
50 - Torque converter clutch system disengagement problem
51 - 1st gear ratio is not specified
52 - 2nd gear ratio is not specified
53 - 3rd gear ratio is not specified

-------------------------------------------------------------



CRUISE CONTROL ERROR CODES


you need to ground pins 4 and 5 and then hook up a test light/multimeter to pin 13.
Then turn the ignition to "ON" and turn the cruise control switch on. The test light/multimeter will then spit out the codes.

CODES:

11 - Auto-cruise vacuum pump drive system
12 - Vehicle speed signal system
14 - Auto-cruise vacuum pump power supply system
15 - Auto-cruise control switch
16 - Auto-cruise control-ECU
17 - Throttle position sensor system


CODE - OPERATION - Operation Judgement
21 - SET - The system recognises that the set switch is ON
22 - RESUME - The system recognises that the resume switch is ON
23 - Stop light switch - The system recognises that the stop light switch (brake pedal) is ON
24 - Vehicle Speed Signal - The system recognises that the vehicle speed is 40km/h or higher
25 - Vehicle Speed Signal - The system recognises that the vehicle speed is lower than 40km/h
26 - Park/neutral position switch - The system recognises that the park/neutral position switch is ON
27 - CANCEL - The system recognises that the cancel switch is ON
28 - Throttle position sensor signal - The system recognises that the throttle position sensor voltage is 1.5V or more
29 - Closed throttle position switch - The system recognises that the closed throttle position switch is OFF


-------------------------------------------------------------

ABS Error Codes


if you don't have ABS these codes don't apply to you

CODES

11 - Front right wheel speed sensor (open or short circuit)
12 - Front left wheel speed sensor (open or short circuit)
13 - Rear right wheel speed sensor (open or short circuit)
14 - Rear left wheel speed sensor (open or short circuit)
15 - Wheel speed sensor (abnormal output signal)
16 - Power supply system
21 - Front right wheel speed sensor (defective sensor)
22 - Front left wheel speed sensor (defective sensor)
23 - Rear right wheel speed sensor (defective sensor)
24 - Rear left wheel speed sensor (defective sensor)
25 - Free wheel engage switch
26 - Center differential lock detection switch
27 - Rear differential lock detection switch (applies to vehicles with or without rear differential lock)
32 - G sensor system
33 - Stop light switch system
41 - Front right solenoid valve
42 - Front left solenoid valve
43 - Rear solenoid valve
51 - Valve relay
53 - Motor relay, motor
63 - Replace the ABS ECU
64 - Replace the ABS ECU

-------------------------------------------------------------------------------------------------


This uses the A/T oil temp warning light.


11 - Throttle position sensor system (malfunction of sensor Open or short circuit)
15 - Oil temperature sensor system (Open circuit)
16 - Oil temperature sensor system (Short circuit)
21 - Ignition signal system (Short circuit)
22 - Ignition signal system (Open circuit)
23 - Signal line from ECM to TCM (engine coolant temperature signal line) (Open circuit)
24 - Signal line from ECM to TCM (Engine coolant temperature signal line) (Short circuit)
29 - Park/neutral position switch system (Short circuit)
30 - Park/neutral position switch system (Open circuit)
31 - Input shaft speed sensor system (Open circuit)
32 - Output shaft speed sensor system (Open circuit)
41 - Shift solenoid No. 1 system (Open circuit)
42 - Shift solenoid No. 1 system (Short circuit)
43 - Shift solenoid No. 2 system (Open circuit)
44 - Shift solenoid No. 2 system (Short circuit)
47 - Lock-up solenoid system (Open circuit)
48 - Lock-up solenoid system (Short circuit)
49 - Torque converter clutch system engagement problem
50 - Torque converter clutch system disengagement problem
51 - 1st gear ratio is not specified
52 - 2nd gear ratio is not specified
53 - 3rd gear ratio is not specified
54 - 4th gear ratio is not specified
chain rattle is offline  
Reply

Quick Reply
Message:
Options

Register Now



In order to be able to post messages on the Mitsubishi-Forums.com forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page



Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

 
For the best viewing experience please update your browser to Google Chrome