Mitsubishi Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Howdy, just bought my 2nd 2007 outlander and have a 2012 as well. This 07 had the bank 1 cat and both sensors replaced by a small shop and it is noisy and still posting codes occasionally. The shop left one or more nuts off the manifold. How in the world is this accessed? Had hoped to remove one nut so I can find a proper replacement but it looks impossible from below, wanted to check here before I pull the intake manifold.
Thanks folks!
 

·
Registered
Joined
·
3 Posts
Discussion Starter #2
Update: For future reference the nuts are M10 x 1.25 flange nuts. Pulled the intake, time for spark plugs anyway, that makes it relatively easy to get the heat shield off and access some of the nuts.
 
1 - 2 of 2 Posts
Top