Mitsubishi Forums banner
1 - 1 of 1 Posts

1 Posts
Discussion Starter · #1 ·
Can anyone help with fitting a bee r rev limiter in to a 2007 Mitsubishi Lancer (not Evo)
I’ve tried everything and many different wire combinations, I’ve used the ground from the ecu (pin 26) and I’ve used the power from the ecu (pin 25) ,
The green and yellow wires from the bee r are what seem to be not working , someone please advise
Here is the ecu pin out I’ve been using ,
I know it’s the 260 Evo one but so far all the wires seem to be in the same place
1 - 1 of 1 Posts