Mitsubishi Forums banner
1 - 4 of 4 Posts

·
Administrator
2021 MR Triton
Joined
·
665 Posts
At the very back of the cylinder head. Early ones, which your is had a problem with water getting into the connector and corroding. Strangely enough i havent heard of this in a few years, but replaced one last week. Advise getting the associated wiring harness, as the corrosion will be in the connector too. Its only about 6 inches long, so not hard to change or too expensive
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top