Mitsubishi Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
I bought a cold air intake for my 2015 Lancer GT. It has a CVT trans. Their intake (part number 63-5506) was designed for a manual trans. The main issue I have run into is the mass airflow sensor is completely different. I found one that I believe is the one they used (Spectre part number MA333). I just want to know that if I change it it won't either give my ecu a bad reading or completely give me a check engine light. I am aware the wire is on the opposite side of the sensor, I should be able to work around that. I plan on calling K&N tomorrow to verify the part number, its currently past their hours. I just would like to know if the sensor will work so I don't find out the hard way.
 

·
Registered
Joined
·
6 Posts
Discussion Starter · #2 ·
Nevermind, I opened up the whole for the mass airflow sensor and zip tied it to the duct and its working perfectly.
 
1 - 2 of 2 Posts
Top