Mitsubishi Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
I had a few worn motor mounts that I decided to replace all of them along with some front suspension work. After I put everything else back together when starting the car and putting it in gear whether it be reverse but especially drive and foot on brake I have a bad vibration inside the cabin which is felt through the steering wheel and dashboard that wasn't there before. Can somebody enlighten me on maybe what I did wrong or what I could do to alleviate the problem? 2.4l
 

·
Registered
Joined
·
6 Posts
I replaced motor mounts on my lancer and had a similar problem with vibrations being worst after replacement compared to the old ones. Turns out that the transmission mount was defective from the factory. I took it out again for comparison and it was not welded right and was therefore crooked and causing all the vibration.
 
1 - 2 of 2 Posts
Top