Mitsubishi Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
No start issue. New fuel pump, filter, idle air control, fuel pressure regulator. Plugs. Rotor. Water pump and crossover tube seals.
I am getting 40 psi fuel pressure. Good spark. Noid light flashes. Pulled fuel rail and watched all 6 injectors spray a nice double stream. Pulled o2 sensor to see if convertor is plugged. Compression 180 on 3 cyl. 170 on other 3 cyl. All timing marks are right on the money. Rolled it over with plugs out but still hooked up and all 6 t 1 ft blue flame out of spark hole but It will not start.
Pulling plugs after trying to start and they are wet. Any help is greatly appreciated. I need to figure this out. Thanks.
 

·
Registered
Joined
·
4 Posts
Discussion Starter #4
Thanks for your reply. They all read 0 until when trying to start it reads rpm, duty %. Oxygen content. Maf pressure and a few others. All are within.secs. is there one in particular i should check?
 
1 - 4 of 4 Posts
Top