Mitsubishi Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
51 Posts
Discussion Starter #1
It seems like this question is asked over and over and I am sick of typing individual posts over and over....HERE IS THE INSTRUCTIONS FOR THE RAIDO!!!!! I have the manual and this is what is says....
1.Place the ignition key in the "ACC" position.
2. Press the button (lg volume knob) and codE will be shown in the display in the upper middle of the instrument panel.
3. Press no. 1 thru no. 4 memory select button (used to change cd tracks) to set the 4 didgit security code.
4. Press the tape or cd button and a beep will be heard. The system is now in operation mode.
5. If the securtiy codes do not match a "1Err" message is shown in the display in the upper middle of the instrument panel. In a few seconds, it will change to "code". Repeat steps mentioned.
6. If a mistake is made during the input of the security code, the anti-theft system will aloow up to three attempts to enter the correct code.
7. The second error is displayed as "2 err", and the third is "3err" and then the display changes to "off". If this should occure the unit will not opperate. Contact an authorized Mitsubishi dealer for assiatance. biggrin.gif
 

·
Registered
Joined
·
1 Posts
if u input the code wrong 3 times and ur display reads off just leave the ignition in the on position for about an hour and the unit will reset and display code once more so u can try again.
 
1 - 2 of 2 Posts
Top