Mitsubishi Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hi All,

I have a 2003 Verada GTVi with a manual conversion and have just had the engine replaced with a 91k used motor.

After the engine swap, the speedometer initially worked perfectly, but the needle started dipping erratically after about 20 minutes before failing completely. Second and third journeys, exactly the same - started OK, failed after 20 minutes or so.

I have tried pulling the sensor connector and re-attaching as it seemed the most likely issue, but it made no difference.

I am thinking it is most likely the sensor - any thoughts on that?
 
1 - 1 of 1 Posts
Top