Mitsubishi Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Folks, I fitted a hitch to a 07 AWD Outlander & was expecting to splice in the cables to the existing brake/turn/light wires when I spotted a few spare connectors. Lo & Behold I think I found the connector I need, only thing is I unintentionally managed to remove the wires from the connector on harness when checking it out. I've scoured the Net for a schematic but there is nothing for the tow harness connectors. Is there anyone one out there who could tell me the wiring pin out for the connector again so I can insert the wires to the correct pin locations on connector. Or if someone wouldn't mind taking a picture of their connector with wires inserted.

The connector in question is in the rear RHS of my jeep but thats a right hand drive model.

I'd appreciate it big time. Hopefully I'll get a result. Take Care everyone.
 
1 - 1 of 1 Posts
Top